UHD drives

Forum for discussions about UHD-capable dives
Locked
jonghotti
Posts: 989
Joined: Tue May 01, 2018 7:04 pm
Location: San Francisco Bay Area
Contact:

Re: UHD drives

Post by jonghotti »

I’m available to flash drives that have gotten buggered up like this. Happy to do it for free if you can foot the bill for postage.

I’m curious to see a drive in this state.

This is not an offer, however,
to flash drives with unfriendly firmware recently purchased from a vendor other than myself.

Email alexcoluzzi32@gmail.com
The Original "UHD Friendly" Drive Seller
https://www.makemkv.com/forum/viewtopic ... 20&t=17829
Mistar Muffin
Posts: 2
Joined: Wed Dec 12, 2018 6:46 pm

Re: UHD drives

Post by Mistar Muffin »

jonghotti wrote:
Thu Dec 13, 2018 1:40 am
I’m available to flash drives that have gotten buggered up like this. Happy to do it for free if you can foot the bill for postage.

I’m curious to see a drive in this state.

This is not an offer, however,
to flash drives with unfriendly firmware recently purchased from a vendor other than myself.

Email alexcoluzzi32@gmail.com
Apparently I don't have permission to reply to PMs. I guess because I'm newly registered? Anyways I flashed 3.00 and rebooted and was able to read a UHD disc. I flashed 3.02 and rebooted and was able to still read the disc. Today I am no longer able to read the disc. I flashed back to 3.00 again and no change this time.
jonghotti
Posts: 989
Joined: Tue May 01, 2018 7:04 pm
Location: San Francisco Bay Area
Contact:

Re: UHD drives

Post by jonghotti »

I would have flashed to 3.01 to start but that’s just a personal preference.
I’ve never heard of a flash not taking like that. Did you actually rip the disc after going to 3.02 or just pop a disc in and make sure it was recognized?
That’s the only thing I can think of.

I would go back to your orginal dump and mix that with clean 3.01 and flash that. Then when the flasher says done writing close the app, let the drive reboot then run the flasher again and make sure it’s reporting 3.01

As a rule I do not trust 3.02. It’s been proven that there are multiple builds out there with the same version number yet capable of either rendering your drive friendly or very unfriendly.

For that reason I’d stick with 3.01.
The Original "UHD Friendly" Drive Seller
https://www.makemkv.com/forum/viewtopic ... 20&t=17829
jonghotti
Posts: 989
Joined: Tue May 01, 2018 7:04 pm
Location: San Francisco Bay Area
Contact:

Re: UHD drives

Post by jonghotti »

Mister Muffin did you see my PM? You just weren’t able to reply to it?
Sorry about that not sure what the rules are.

I can always be reached at alexcoluzzi32@gmail.com let’s talk about this issue.
The Original "UHD Friendly" Drive Seller
https://www.makemkv.com/forum/viewtopic ... 20&t=17829
dflagel
Posts: 2
Joined: Tue Dec 11, 2018 6:45 pm

Re: UHD drives

Post by dflagel »

jonghotti wrote:
Tue Dec 11, 2018 9:56 pm
I just replied to your email sir.
I got the drive and it works great! Thanks for the fast response and great service!!
markm75
Posts: 3
Joined: Fri Dec 14, 2018 8:56 pm

Re: UHD drives

Post by markm75 »

I've seen this drive mentioned in this thread, but its not clear to me if it "should" work..

I have the GGW-H20L drive.. unsure which firmware (dont think i ever updated it).. Does anyone else have this and know if it works.. when i put a disc in with makemkv it just sits there "scanning cd rom devices".
MartyMcNuts
Posts: 2460
Joined: Wed Nov 22, 2017 11:45 pm

Re: UHD drives

Post by MartyMcNuts »

@markm75,

I'm pretty sure that drive won't work. I have one of them sitting on a shelf. I think it is from around 2010-2011. For UHD Friendliness, you need a drive from late 2015+
Cheers :D
----------------------------------------------------------------------------------------------------------------------------
For UHD enabled drives (AU/NZ/SG) & DIY Single Drive Flasher (WW): https://www.uhdenableddrives.com
mhinagoya
Posts: 1
Joined: Sat Dec 15, 2018 1:19 am

Re: UHD drives

Post by mhinagoya »

jonghotti wrote:
Thu Dec 13, 2018 1:40 am
I’m available to flash drives that have gotten buggered up like this. Happy to do it for free if you can foot the bill for postage.

I’m curious to see a drive in this state.

This is not an offer, however,
to flash drives with unfriendly firmware recently purchased from a vendor other than myself.

Email alexcoluzzi32@gmail.com
Ladies and gents, I just bought a drive from jonghotti (Alex) and he got it to me in a couple of days. It works perfectly, as advertised. Alex is a stand up guy and when he makes an offer like this, I wouldn't hesitate to take him up on it.

Bill.
st4evr
Posts: 705
Joined: Tue Mar 06, 2018 11:38 pm

Re: UHD drives

Post by st4evr »

And to be clear, not just any drive 2015+. The list discussed in detail in this thread and several other places online exist for specific reasons. The drives need to meet these specific requirements to be able to read UHD BD discs/layers. Not all do.
jonghotti
Posts: 989
Joined: Tue May 01, 2018 7:04 pm
Location: San Francisco Bay Area
Contact:

Re: UHD drives

Post by jonghotti »

Thanks Bill, it was my pleasure.
The Original "UHD Friendly" Drive Seller
https://www.makemkv.com/forum/viewtopic ... 20&t=17829
CJ32601@yahoo.com
Posts: 12
Joined: Tue Dec 18, 2018 4:49 am

Re: UHD drives

Post by CJ32601@yahoo.com »

jonghotti wrote:
Fri Dec 07, 2018 9:49 pm
Put ASUS BW-16D1HT version 3.01 on both and be done with it. Works like a charm.

Better yet buy one from me and skip the flashing!
Hey. Still have some drives for sale? I’m very interested in one.
- Chris
jonghotti
Posts: 989
Joined: Tue May 01, 2018 7:04 pm
Location: San Francisco Bay Area
Contact:

Re: UHD drives

Post by jonghotti »

I emailed you buddy.

Anyone else need a drive I've got plenty in all shapes and sizes and prices. alexcoluzzi32@gmail.com
The Original "UHD Friendly" Drive Seller
https://www.makemkv.com/forum/viewtopic ... 20&t=17829
KaraokeAmerica
Posts: 22
Joined: Tue Aug 04, 2015 6:47 pm

Re: UHD drives

Post by KaraokeAmerica »

st4evr wrote:
Wed Dec 12, 2018 8:44 pm
KaraokeAmerica wrote:
Wed Dec 12, 2018 2:44 pm
I think this is related to topic because it specifically involves drive capability.

I have an LG-WH14NS40 with the following info as per MakeMKV:

Drive Information
Manufacturer: HL-DT-ST
Product: BD-RE WH14NS40
Revision: 1.01
Serial number: K92E3OJ4053
Firmware date: 2113-04-04 23:25
Bus encryption flags: 17
Highest AACS version: 61

I have ripped UHD in this drive in the past. However, it suddenly stopped even recognizing UHD disks recently. It still works fine for DVD/Blu-Ray, but if I put in a UHD it simply slow flashes for a minute or so and never recognizes it. It's not just MakeMKV though. AnyDVD doesn't see the disk either and never even tries to scan it.

I have tried 3-4 different disks that will mount in a non-friendly drive right next to it in the same system or a different one, but of course I can't rip the disks in those drives.

Any ideas what could cause this? I have never updated firmware on this drive and like I said, it was working.

Thanks for any help!
A few people reporting this issue had to re-flash UHD Friendly firmware (the same version or one of the other versions) onto the same drive to "kick it" back into working.

This post will provide you with some options on how to do this:

https://www.makemkv.com/forum/viewtopic ... %3A#p67936
Hmmm.......I ordered the Asus drive discussed in this thread. I put in my system along with the LG that stopped working despite never touching the firmware. I have the same issue with that Asus: "no disc inserted in drive". Something else is going on here. Both drives work flawlessly with anything BUT a UHD. I can put a regular Blyu-Ray in either and they are great. These are BOTH supposed to be UHD Friendly drives:

ASUS BW-16D1HT 3.03
HL-DT-ST BD-REWH14NS40 1.01

I do keep my Win10 system up to date with patches. Is it possible somehow that Microsoft disabled this capability?
Billycar11
Posts: 3766
Joined: Sun Aug 24, 2014 5:49 am

Re: UHD drives

Post by Billycar11 »

KaraokeAmerica wrote:
Tue Dec 18, 2018 10:29 pm
st4evr wrote:
Wed Dec 12, 2018 8:44 pm
KaraokeAmerica wrote:
Wed Dec 12, 2018 2:44 pm
I think this is related to topic because it specifically involves drive capability.

I have an LG-WH14NS40 with the following info as per MakeMKV:

Drive Information
Manufacturer: HL-DT-ST
Product: BD-RE WH14NS40
Revision: 1.01
Serial number: K92E3OJ4053
Firmware date: 2113-04-04 23:25
Bus encryption flags: 17
Highest AACS version: 61

I have ripped UHD in this drive in the past. However, it suddenly stopped even recognizing UHD disks recently. It still works fine for DVD/Blu-Ray, but if I put in a UHD it simply slow flashes for a minute or so and never recognizes it. It's not just MakeMKV though. AnyDVD doesn't see the disk either and never even tries to scan it.

I have tried 3-4 different disks that will mount in a non-friendly drive right next to it in the same system or a different one, but of course I can't rip the disks in those drives.

Any ideas what could cause this? I have never updated firmware on this drive and like I said, it was working.
Thanks for any help!
A few people reporting this issue had to re-flash UHD Friendly firmware (the same version or one of the other versions) onto the same drive to "kick it" back into working.

This post will provide you with some options on how to do this:

https://www.makemkv.com/forum/viewtopic ... %3A#p67936
Hmmm.......I ordered the Asus drive discussed in this thread. I put in my system along with the LG that stopped working despite never touching the firmware. I have the same issue with that Asus: "no disc inserted in drive". Something else is going on here. Both drives work flawlessly with anything BUT a UHD. I can put a regular Blyu-Ray in either and they are great. These are BOTH supposed to be UHD Friendly drives:

ASUS BW-16D1HT 3.03
HL-DT-ST BD-REWH14NS40 1.01

I do keep my Win10 system up to date with patches. Is it possible somehow that Microsoft disabled this capability?
you didnt do enough research your asus needs firmware 3.02 or lower and your lg is to old needs to be 2015+
you can make the asus friendly with the guide here https://www.makemkv.com/forum/viewtopic ... 16&t=17058
if you cant do it send it to me i downgrade them for $25
my email is Billycar5924@gmail.com
Buy a UHD drive from the guide and how to video maker: https://www.makemkv.com/forum/viewtopic ... 20&t=17831
UHD Drives Guide: https://www.makemkv.com/forum/viewtopic ... 16&t=19634
Auto flash kit $25 Email me for one Billycar5924@gmail.com
st4evr
Posts: 705
Joined: Tue Mar 06, 2018 11:38 pm

Re: UHD drives

Post by st4evr »

KaraokeAmerica wrote:
Tue Dec 18, 2018 10:29 pm
I do keep my Win10 system up to date with patches. Is it possible somehow that Microsoft disabled this capability?
In addition, no. Windows does not have anything to do with this. Skipping to the end of the thread does you no good. The very specific requirements to support UHD BDs have been discussed literally hundreds of times in this thread and in many other posts in this forum. And why brand new drives recently purchased straight from retailers will no longer work out-of-the-box.

And you have yet to clarify how old that WH14NS40 is. As Billy mentioned, if it's too old it will not work. It's one of the requirements.

Search function works.

https://www.makemkv.com/forum/search.ph ... =BW-16D1HT

https://www.makemkv.com/forum/search.ph ... s=WH14NS40
Locked